User manual CASTOR C5623

[. . . ] Any repairs or adjustment which might be necessary is to be carried out with the utmost care and attention. For this reason we reccomend you always contact the dealer where the appliance was sold ort our nearest Customer Service Centre, specifying the type of problem and the model of your appliance. Do not forget that the original spare parts are only to be found at our Customer Service Centres. GB Cet appareillage, avant de laisser l'usine, a été vérifié et mis au point par du personnel expert et spécialisé, de façon à donner les meilleurs résultats de fonctionnement. Toute réparation ou mise au point qui sera nécessaire par la suite devra être faite avec un maximum de soin et d'attention. [. . . ] To use it, rotate first the knob clockwise by one click onto position ; then, wind up the ringer by further rotating the knob by a nearly complete rotation; finally, turning it backwards, set the desired time. Once the preset time has elapsed, the acoustic signal starts up and the oven is automatically switched off. To switch the oven to the manual operation, thus excluding the timer, turn the knob to its initial position by rotating it counterclockwise by one click until the symbol of the control board matches the reference on the knob. TIMER To programme the timer, press and turn the knob leftwards until it coincides with the hour. (If the knob is turned rightwards, a safety mechanism protects the elements of the timer). COOKING TIMER To programme the cooking time (adjustable from 0 to 180 minutes), turn the knob anticlockwise, but without exerting a pressure and until the disc's window, or the hand, coincides with the requested cooking time. The oven is disconnected and the continuous bell is activated when the preset time is over. To stop the bell, turn the knob leftwards without exerting a pressure, until the port or the hand coincides with symbol ELECTROMECHANICAL PROGRAMMER It is used to programme the oven start and stop. The programmer is fitted with an electric timer for displaying the hour. displays the programmer controls: use knobs A, B, and adjusting ring C, to carry out the necessary adjustments, such as: Knob A: Turn this knob clockwise to correct the time of the timer. (This is done when installing the appliance, when the current is cut out, for controlling both advance and lag, and so on). Knob B: Press and turn this knob clockwise to preset the cooking start time on dial F. Adjusting ring C: Turn this ring clockwise to preset the following: · cooking time (210 minutes max) · manual operation of the oven (position ) · acoustic signal cut off (position ) These signals appear on dial E 21 INSTRUCTIONS FOR USE GB Manual operation Programming the oven may not be necessary. Also symbol (B) is deactivated. Manual Operation The oven may be used manually without any programming. Press key (4) for the manual operation ("AUTO" pilot light off). ELECTRONIC END OF COOKING Setting up the hour Once the electronic connection is over, the display blinks and shows 0. 00. Press both keys at the same time and set out the hour by pressing keys (-) and (+) within the 4 seconds. The oven remains in manual operation and can be used without any further programmation. General remarks · If the horn is not deactivated (as per following instructions), it is cut off after 2 minutes. · All the programmings described hereunder are activated approx. · When the voltage is cut out, all the programmed set outs are erased. Setting out the end of cooking To start the cooking at once, and to automatically set out the time, work as follows: · Select the funcion and the temperature required by the function selector and the thermostat. Set the cooking time to 0. 00 to erase the set out programming and, after the hour reappears, press any one of the keys to reset the manual function (symbol (A) is off). Once the cooking time is over, the horn goes off and the oven is automatically put off, (the hour reappears and symbol (A) blinks). To put off the horn and to take the oven in manual function press any one of the keys (symbol (A) disappears). 25 INSTRUCTIONS FOR USE PILOT LIGHT OF THE THERMOSTAT (°C) GB (if any) It comes on any time the thermostat settles the cooking temperature inside the oven and it is switched off when the oven reaches the preset temperature. PILOT LIGHT FOR THE OPERATION (~) (if any) It signals that the appliance is powered and stays on in all working positions. [. . . ] NEVER USE THE OVEN WITH THE GRILL ELEMENT HANGING DOWN! Cleaning the oven door The inside glass of the oven can be easily removed for cleaning purposes unscrewing, by means of a coin or a screwdriver, the screws fixing it to the counterdoor. Lift the hinge jumpers by your thumb and index fingers, then turn them fully outwards to the end of stroke (Fig. A). Turn the door towards the closure position and lay it on the jumpers: in this way the hinge's spring results as blocked. By fully closing the door the hinges are unhooked from the connection slits which are integral with the oven's muffle (sequence 1, 2, 3 of fig. B). 29 CLEANING AND MAINTENANCE GB Hooking the doors 1. [. . . ]