User manual CANON PIXMA MP600

[. . . ] Important Do not connect the USB cable until after the software is installed. Note To open the Paper Output Tray, put your finger in the rounded indent of the tray and open it gently. (1) Press the { or } button to select the language. [. . . ] Refer to "Error Message is Displayed on the LCD" in the User's Guide on-screen manual. Windows® MP Drivers Installation Macintosh® MP Drivers Installation do W in Note · The screens below refer to Windows XP Service Pack 2 installation. · For Windows XP or Windows 2000, log on to Windows as a member of the Administrators group before continuing. · Before installing the driver, disable all anti-virus programs and automatically loading programs. f Read the License Agreement carefully and click Yes. M ac in to sh w s Follow the on-screen instructions to install the software. If a message asking for your confirmation to restart your computer appears, click OK. The software will begin identifying the printer port being used. Important If you cannot go to the next procedure after 3 minutes, refer to "Troubleshooting" instructions in the User's Guide on-screen manual. Important Since Mac® OS 9, Mac OS X Classic environments, or Mac OS X v. 10. 2. 7 or earlier are not supported, do not connect the machine to these. · · · · Note Use Mac OS X v. 10. 2. 8 to 10. 4. x. Before installing the driver, disable all anti-virus programs and automatically loading programs. g When the list of applications to install appears, confirm the contents, then click Install. Note Move the cursor over items to display explanations of each application. g When the Printer Connection screen appears, connect the h Read the License Agreement carefully and click Yes. a Turn off the machine. (1) Press the ON/OFF button. (2) Make sure that the POWER lamp stops flashing. Follow the on-screen instructions to install the software. Note When the User Registration screen appears, follow on-screen instructions to register your product. You will need your product serial number, which is located on the inside of the machine. See Step 1- f on the front page. i Follow the on-screen instructions to register your product. a Connect one end of the USB cable to the computer, the other to the machine. Note Make sure the machine is turned on. b Turn the computer on and start Windows. Important If you see the Found New Hardware Wizard, remove the USB cable. Then proceed from step 3 to install the MP Drivers. j When the Installation completed successfully screen appears, click Restart. b Turn on your Mac. c Insert the Setup CD-ROM. The setup program should run automatically. Note The setup program should run automatically. [. . . ] Select Custom Install in order to choose the options you would like to install. Part no. Microsoft and Windows are either registered trademarks or trademarks of Microsoft Corporation in the U. S. [. . . ]