User manual CANON LV-7292S BROCHURE

[. . . ] Make sure to observe the cautions given here. When displaying the projector by hanging it from the ceiling using this mounting hanger, the ceiling should have sufficient strength to support both the projector and the mounting hanger. Before installation, check the weight of the projector and the mounting hanger, then confirm the strength of the ceiling. [. . . ] Before installation, check the weight of the projector and the mounting hanger, then confirm the strength of the ceiling. If the ceiling does not have sufficient strength, be sure to sufficiently reinforce it. INSTALLATION CAUTIONS Make sure to install this mounting hanger from a ceiling that is level. In order to prevent swaying caused by earthquakes or vibration, take proper anti-swaying steps using wires, etc. during installation. The total weight of this mounting hanger's main body is 1. 7 kg. Screw (A). . . 11 pcs. Assembly/ Installation Manual Parts included in package Assembly and installation procedure Refer to Fig. Turn over the projector main body, and attach it to the main body mounting fitting with screws (A)and (B). Tighten securely the wire clamp with the drop prevention wire, and push down the adjuster in the main body. A Screws (included in package) 2. Hang securely the drop prevention wire included in the package to the adjuster in the main body (2 positions). 4. Attach the drop prevention wire to the main body mounting fitting with two A screws (M4 x 12 mm) included in the package. Attach the drop prevention wire on the opposite side in the same way. Measures to prevent the projector from falling * Make sure to take measures to prevent the projector main body from falling as explained here. c Ceiling hanging fitting Main body mounting fitting v Fix securely the main body mounting fitting to the ceiling hanging fitting with four A screws (M4 x 12 mm) included in the package. 2 (LV-CL08) 03. 8. 26 7:40 PM 7 Fig. 2 Adjustment Angle fine-adjusting screw This screw facilitates fine adjustment of the projection angle while the projector is half fixed. After determining the projection angle, make sure to fix securely the projector with the angle adjusting screws. Angle adjusting screws (with hexagon socket) Rotated 360° to the left and right. Tilted 15° in the 360° rotation range. 15° 15° CAUTION After the projector angle is fixed once, if the angle is adjusted again in the fixed status, the fixed area may be deformed and adjustment might no longer be possible. [. . . ] 2 Adjustment Angle fine-adjusting screw This screw facilitates fine adjustment of the projection angle while the projector is half fixed. After determining the projection angle, make sure to fix securely the projector with the angle adjusting screws. Angle adjusting screws (with hexagon socket) Rotated 360° to the left and right. Tilted 15° in the 360° rotation range. 15° 15° CAUTION After the projector angle is fixed once, if the angle is adjusted again in the fixed status, the fixed area may be deformed and adjustment might no longer be possible. [. . . ]