User manual CANDY CDF8 312/1

[. . . ] Thank you for choosing a Candy appliance; quality dishwashers which guarantee high performance and reliability. candy manufacture a vast range of domestic appliances: washing machines , washer/dryers , cookers , microwave ovens , ovens and hobs , refrigerators and freezers. Ask your dealer for the catalogue with the complete range of Candy products. Please read this booklet carefully as it provides important information regarding the safe installation, use, and maintenance of the machine, together with some useful advice on how to achieve the best results from your dishwasher. [. . . ] When loading the lower basket, please ensure that the plates or others do not obstruct the detergent dispenser. The concentrated detergents, with reduced alkalinity and with natural enzymes, in conjunction with 50°C wash programmes, have a smaller impact on the environment and they protect the dishes and the dishwasher. The 50°C wash programmes purposely exploit the dirt-dissolving properties of the enzymes, allowing therefore, with the use of the concentrated detergents, to achieve the same results of the 65°C programmes but at a lower temperature. IMPORTANT Any problems which arise as a direct result of the use of these products are not covered by our warranty. Since not all detergents are the same the instructions on the boxes of detergent can vary. We should just like to remind users that too little detergent does not clean the dishes properly whilst too much detergent will not produce better results and is also a waste. Please note that using the "ALL in 1" combined detergents, the rinse aid and salt indicator lights (only used on selected models) are superfluous, so you must ignore the lights. If washing and/or drying problems occur, we recommend you return to use traditional separate products (salt, detergent and rinse agent). This will ensure that the water softener in the dishwasher operates correctly. In this case, we recommends that you: Combined detergents The amount of detergent to be used varies according to how dirty the dishes are and on the type of dishes to be washed. IMPORTANT Do not use an excessive amount of detergent and help limit damage to the environment at the same time. The detergents that also contain the rinse aid must be placed in the wash section of the detergent container. The rinse aid container must be empty (if it is not empty, set the rinse aid regulator to lowest position before using combined detergents). "ALL in 1" combined detergents If you are planning to use “ALL in 1” (“3 in 1 “/ “4 in 1”/ “5 in 1”, etc. Those with built in salt and/or rinse agent, we would advise the following: ■ refill both the salt and rinse aid container; ■ run one normal washing cycle without a load. Please note that on return to the use of conventional salt, a number of cycles will be required before the system becomes fully efficient again. 17 A 16 ■ read carefully and follow the manufacturer’s instructions given on the packaging; LOADING THE RINSE AID The rinse aid The rinse aid, which is automatically released during the last rinsing cycle, helps the dishes to dry quickly and prevents spots and stains forming. A “4”) consists of: a central container that traps the larger particles; a flat gauze that continuously filters the wash water; 1 Filling the rinse aid container The rinse aid container can be found to the left of the detergent container (fig. To open the lid, push the reference mark and, in the same time, pull the tab of opening. It is always advisable to use rinse aid that is specifically designed for dishwasher. Check the rinse aid level through the indicator eye (C) which is located on the dispenser. C a micro filter, located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse. [. . . ] 50°C 32 5 YES YES YES Wash with prewash For wash programmes with prewash, it is advisable to add a second dose of detergent (max. 26 27 "ALL in 1" button Main wash Clean filter WATERCONTROL-SYSTEM (CDF8 312 X) The water-stop device protects against water damages caused by leaks on the fill hose which could develop due to natural ageing of the hose. In the water-stop system the leaking water fills the corrugated hose and activates a stop valve which cuts off the water supply to the machine. If the hose is not long enough for correct connection, it must be replaced with a longer one. [. . . ]