User manual BRITAX DUO PLUS

[. . . ] We are pleased that our DUO plus may accompany your child safely through a new stage of his or her life. In order to protect your child correctly, the DUO plus must always be used and installed as described in these instructions. If you have any further questions regarding its use, please feel free to contact us. Please make sure you study the enclosed list of approved vehicles, which is continuously supplemented. [. . . ] Checklist for correct installation For the safety of your child, check that. The tongue and the buckle of the vehicle seat belt are not positioned in the belt guides of the child seat. The diagonal belt is only clamped by the lock-off which is located on the opposite side from the car seat belt buckle. Removal To remove the child seat open the buckle of the vehicle seat belt and take the diagonal belt with a short pull out of the belt lock-off 9. This countermovement releases the interior clamping of the belt lock-off 9 and the clamping lever 8 is now easy to open. Before you install the child seat in the vehicle, please ensure that the shoulder belts are adjusted to the correct height. The shoulder belts 10 must run at shoulder height or a little above the height of the child's shoulders. The shoulder belts 10 must not run behind the back of the child or at ear height or above the ears. The shoulder belts are adjusted as follows: Loosen the harness straps as much as possible (refer to 4. Push with the finger of one hand on the adjuster 15 and with the other hand pull both shoulder belts 10 simultaneously towards you. Open the buckle 17 of the child seat by pressing the red release button . Hook buckle tongues 19 into the rubber holders 29 (are not available on all covers) on the cover on the left and right side. Take the buckle tongues 19 left and right from the rubber holders 29 on the cover. The function of the buckle is very important for the safety of your child. The buckle tongues are only slowly ejected when pressing the red release button. Grasp the metal plate under the seat shell, with which the crotch belt 20 is secured to the seat shell. Push it with the narrow side upwards through the belt slot 22 in the cover and into the seat shell. Please check the correct fitting of the metal plate by pulling up on the crotch belt 20 several times. Feed Velcro of the crotch belt pad 21 into the crotch belt 20 and close. 6 Checklist for correct securing of your child For the safety of your child, check that. The belts of the child seat are close to the body, without restricting the child. Sitting / Resting / Sleeping - Adjustable seat shell From sitting to sleeping: Push the adjusting handle 23 up and pull the seat shell forwards. [. . . ] First put the tongues 19 of the two harness straps together and engage in the buckle 17 (refer to 4. Feed the belt loop (black stitching) into the cover and into the outer side slot 25 of the seat shell. Push the belt loop back and hook into the short side of the metal part 30. Pull the belt until the metal part 30 lies straight against the seat shell. [. . . ]