User manual BOSE ACOUSTIC WAVE CONNECT KIT FOR IPOD

[. . . ] Protect the power cord from being walked on or pinched, particularly at Unplug this apparatus during lightning storms or when unused for long When the apparatus has been damaged in any way: such as powersupply cord or plug is damaged; liquid has been spilled or objects have fallen into the apparatus; the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped ­ Do not attempt to service this product yourself. Opening or removing covers may expose you to dangerous voltages or other hazards. Please call Bose to be referred to an authorized service center near you. To prevent risk of fire or electric shock, avoid overloading wall outlets, Do not let objects or liquids enter the product ­ as they may touch Dangerous voltage points or short-out parts that could result in a fire or electric shock. [. . . ] To avoid extreme volume when using headphones, especially for extended periods. Power Pack only (left) or Power pack with line cord (right) This kit is fully compatible with most iPod models. For the Acoustic Wave® connect kit to work as expected, your iPod must have the latest version of iPod software installed. If you need to upgrade, simply visit the Apple iPod website and follow the instructions there. We recommend that you place the dock to the right of your Acoustic Wave music system II so that your iPod has minimal effect on FM or AM reception. Be sure the IR sensor on the front of the iPod dock is visible and aligned with the Acoustic Wave system IR sensor so both products respond to the remote. Please be sure to make all other connections before plugging these products into a power outlet. Connect the dock to the Acoustic Wave music system II (as shown below) or to the Acoustic Wave Music system with CD changer (as shown on page 5). Acoustic Wave® music system II with CD changer Connect the free end of the power pack cable to the dock. We recommend replacing the remote that came with your Acoustic Wave® II system with this new remote (shown below). Then you can use the new remote exclusively (not the buttons on your Acoustic Wave® II system), to keep your iPod and system performing together as intended. Note: The remote that came with your Acoustic Wave® system can also be used to control the iPod kit. Use the AUX button on the original remote instead of the iPod button on the new remote. Most of the remote control buttons are described in your Acoustic Wave® II system owner's guide. The response to some remote commands depends on which source (FM/AM/ CD/iPod/AUX) is playing. If the remote does not work as you expect, press the button for that source to reset the intended mode of operation. To hear your iPod play, you may need to press the AUX 1-2 button to select the input used to connect the dock. Insert your iPod firmly into the dock and make sure it is securely seated in the dock adapter. Even if the paused iPod turns off automatically, it continues to charge. If you prefer, you can replace this dock adapter with the adapter specifically designed for and provided with your iPod. [. . . ] Be sure the audio cable from the dock is connected to INPUT AUX 1 on the changer. press iPod and check to see that AUX 1 appears on the CD changer display. The Bose® system speakers play even when headphones are plugged into the docked the iPod. This silences the system so the sound plays through the headphones only. [. . . ]