User manual BORETTI BVW96

[. . . ] Safety information Product description Control panel First use Setting the water softener Use of dishwasher salt Use of rinse aid Daily use Loading cutlery and dishes Use of detergent Multitab function Select and start a washing programme 71 73 74 75 75 76 77 78 79 81 82 83 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Never lift or lower the basket on one side only With the upper basket raised adjust the cup racks in the lowest position. After loading your machine always close the door, as an open door can be a hazard. please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Using no more than the correct amount of detergent contributes to reducing pollution. The activation/deactivation of the rinse aid is only possible with the multitab function active. Simultaneously press and hold function buttons B and C , until the lights of function buttons A , B , and C start flashing. Press function button B , the lights of function buttons A and C go off while the light of function button B continues to flash. To activate the rinse aid dispenser, press button B again, the End indicator light comes on, indicating that the rinse aid dispenser has been activated. To deactivate the rinse aid dispenser again, follow the above instructions until the End indicator light goes off. If you decide to revert back to the use of individual detergents we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. After having selected the washing programme, press the delay start button until the indicator light corresponding to the chosen hours flashes (3h, 6h or 9h). Close the door; the countdown will continue from the point at which it was interrupted. Close the door; the programme will start from the point at which it was interrupted. cancel a delay start or a washing programme in progress · Simultaneously press and hold the two function buttons B and C until all the programme lights come on. If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. ­ The indicator light of the programme just ended remains on. Leave the appliance door ajar for a few minutes before removing the dishes. The dishes should therefore be allowed to cool down before removing from the appliance. ⷠEmpty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. ⷠWater may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. [. . . ] Water inlet hose with safety valve After connecting the double-walled water inlet hose, the safety valve is next to the tap. Therefore the water inlet hose is only under pressure while the water is running. If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. Please take care when installing the water inlet hose: · the electrical cable for the safety valve is in the double-walled water inlet hose. [. . . ]