User manual BORETTI B402

[. . . ] If the customer used parts or accessories that are not recommended or provided by the When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and/or injury to persons, including the following: read all instructions. Make sure that your outlet voltage Corresponds to the voltage stated on the rating label of the coffee maker. To protect against fire, electric shock and injury to persons do not immerse cord, plug or unit in water or other liquid. Close supervision is necessary when any appliance is used by or near children. [. . . ] Remove the orange silicon rubber ring from The bottom of the water reservoir. First remove and then wash the water reservoir, the milk reservoir, the porta-filter, the three filters and measuring scoop in a mixture of mild detergent and water. Refer to the instructions on "PLACING THE PORTA-FILTER" section before placing or removing the porta-filter and filter from the unit. NOTE: In order for your unit to work properly time after time, clean it after every use. Important: prime the unit To prime unit, run the steam cycle for 90 seconds by following the steps below: 1. Fill water reservoir between the "Min" and "Max" levels. Fill the milk reservoir with water between the "Min" and "Max" levels. Place the porta-filter in the unit Ensuring it is properly locked and place a cup under it. Also, make sure the tip of the frothed milk dispensing tube is inside the cup. Once this process is completed, the three control panels will turn on solid. Fill the reservoir with water, you may either use a jar to fill it up or remove it from the unit And then fill it up under the tap. If you have removed it from the unit to fill up with water, please make sure to place it back tightly in its place. Fill the reservoir with the desired amount of water ensuring it ranges within the"MIN" and "MAX" markings on the tank. Close the water reservoir lid and place it back in the unit ensuring it fits tightly. Filling the milk reservoir If you plan to prepare cappuccino or latte, remove the milk reservoir from the unit and open the lid then pour the quantity of cold milk you estimate you will need between the "Min" and"Max" levels. When done, place the milk reservoir back in the unit ensuring it fits tightly. FOR A SINGLE SHOT­ use the filter for a single shot of espresso if using ground coffee. To insert the selected filter in the porta-filter, make sure to Align the notch on the filter with the groove inside the porta- 1 Turn the filter to the left or right to lock in place. NOTE: To remove and clean the filter, turn filter to the left or right 2 To align the filter notch with the groove inside the porta-filter. WARNING: Make sure the filter has cooled before attempting to remove the filter. Filling with ground coffee Fill the filter with fresh, fine ground espresso coffee (do not overfill). Note: the ground coffee amount shouldn't exceed the MAX mark Clean any excess coffee from the rim to ensure proper fit under brew head. [. . . ] do not use abrasive cleaners or scouring pads , as They will scratch the finish. This can adversely affect the seal between The brew head and the porta-filter while brewing espresso. Too much coffee in the Milk is not foamy after frothing or it is not coming out of the frothing tube Milk is not cold enough. Follow the instructions to clean the milk reservoirs & frothing tube. [. . . ]