User manual BEMIS 497300

[. . . ] Disconnect the appliance from the power supply before servicing (pull out the plug or "trip" the circuit breaker). This dishwasher should only be installed under a continuous countertop secured to adjacent cabinetry. Install the dishwasher as outlined in the included Installation instructions. Only use detergents and rinse aids recommended for residential dishwashers. [. . . ] Longer items such as soup ladles, spatulas, mixing spoons and long knives should be placed lengthwise in the indentation in the middle of the cutlery tray. The cutlery tray insert is removable. Spoon heads should be placed in contact with the serrated retainers of the cutlery tray so water can run off. If a spoon handle does not fit securely between the holders then place it like the forks and knives. Make sure that the upper spray arm can rotate freely after the tray is slid in; otherwise the rotation of the spray arms may be inadequate for a thorough cleaning. 26 Loading the dishwasher Items not suitable for dishwashers: ­ Cutlery with wooden handles. ­ Glued items such as old knives with handles that are glued together around the shank of the blade. ­ Silverware previously cleaned with a silver polish may be damp or spotted at the end of a program where water has adhered to the polish. Silver that has been cleaned in an immersion dip is usually dry at the end of a program, but may tarnish. These include egg yolk, onions, mayonnaise, mustard, legumes, fish, fish brine and marinades. ­ Clouding or etching may occur on glasses after frequent washing. Miele recommends: ­ Wash delicate glassware using the "Economy" program or the "China & Crystal" program to reduce the risk of clouding. ­ There are no standard guidelines for washing glassware but, when in doubt wash by hand. ­ When purchasing new dishes and cutlery, make sure they are dishwasher safe. The "Start" indicator light (18) goes out and the "Rinse" indicator (15) lights. reactivating the water softener) could be omitted. 30 Operating the dishwasher Program sequence indicator lights (15) The "Rinse" indicator light comes on in the Prewash, Main wash, Interim rinse and Final rinse stages of a program. The "Drying" indicator light comes on during the drying stage of a program. The "End" indicator light comes on when the program has finished. Turning off the dishwasher At the end of a program: ^ Turn the program selector (17) to "Stop". The "End" indicator light (15) goes out and the "Start" indicator (18) lights. The dishwasher continues to use electricity until turned off using the "On/Off" button. while on vacation, the water valve should be turned off. At the end of a program A program has finished when the "End" indicator lights (15) in the program sequence display. The dishwasher can now be opened and unloaded (see "Unloading the dishwasher"). If the dishwasher is not opened, the fan will continue for a few minutes to remove any remaining moisture. Only open the door immediately after a program has ended if dishes or cutlery are urgently needed. Turn off the dishwasher if another program is not going to be started immediately. 31 Operating the dishwasher Interrupting a program A program is interrupted as soon as the door is opened. [. . . ] ^ Turn the program selector to "Economy 55 °C/130 °F". ­ If the "Top Solo" indicator does not light, the water intake time is set to normal. ­ If the "Top Solo" indicator lights, the increased water intake time is set. The "Top Solo" indicator light will illuminate or go out each time the button is pressed. [. . . ]