User manual BEMIS 496800

[. . . ] To avoid injury and machine damage, read the operating instructions carefully. The manufacturer cannot be held responsible for damage or injury caused by improper use or for uses other than those for which the appliance is intended. Repairs should only be performed by a qualified and competent person. Disconnect the appliance from the power supply before servicing (pull out the plug or "trip" the circuit breaker). This dishwasher should only be installed under a continuous countertop secured to adjacent cabinetry. Install the dishwasher as outlined in the included Installation instructions. [. . . ] Some food may contain natural dyes that can discolor plastics in the dishwasher (e. g. The stability of plastic items are not affected by this discoloration. 24 Loading the dishwasher Loading examples Upper basket Cup rack For small, light weight, or delicate items such as cups, saucers, glasses, and dessert bowls, as well as heat resistant plastics. Flat pans can also be placed in the upper basket. The adjustable cup rack can be raised to make room for taller items or lowered to double stack smaller items. 25 Loading the dishwasher Adjusting the upper basket The upper basket height is adjustable. If tall items are being washed, more room can be made by raising or lowering the upper basket. Do not set the angle to the extreme one side at the highest setting and one side at the lowest. Depending on the setting of the upper basket, the following plate dimensions can be accommodated. Upper basket position Top Middle Bottom Plate diameter Upper Lower basket basket 7 3/4" 12" (20 cm) (30 cm) 8 1/2" 11" (22 cm) (28 cm) 9 3/8" 10" (24 cm) (26 cm) ^ Pull up the levers at the sides of the upper basket and adjust the basket height. ^ Release the levers and the basket will lock in place. 26 Loading the dishwasher Lower basket For larger and heavier item such as plates, serving platters, saucepans, bowls, etc. Do not place thin , delicate glassware in the lower basket unless a special basket with glassware insert is installed. 27 Loading the dishwasher Cutlery tray For best results cutlery should be grouped in zones, one for knives, one for forks, etc. Place the blades of knives and the tines of forks between the holders. Spoons should be placed in the opposite direction with the handle in the holder. In most cases the "Light Wash", the "Normal" or the "Sani Wash" program will give excellent results. Available programs and their applications are listed in the Program Chart. 31 Operating the dishwasher Turning on the dishwasher ^ Open the water valve, if closed. The "On" indicator lights. End of a program The end of a program buzzer sounds when a program has finished. (see "Additional features"). Starting a program ^ When selecting a program, refer to the Program Chart . reactivating the water softener) could be omitted. Turning off the dishwasher At the end of a program: ^ Open the door a few inches (5 ­ 6 cm). The dishwasher will continue to use electricity until it has been turned off. 32 Operating the dishwasher The dishwasher can now be unloaded (see "Unloading the dishwasher"). The water valve should be closed if the dishwasher will not be used for a long period of time, (e. g. while on vacation). Interrupting a program A program is interrupted as soon as the door is opened. When the door is closed, the program will continue from the point it was at before the door was opened. Close the door firmly until it clicks into place Changing a program If the door has not been closed after selecting a program: ^ Simply press the button for the new program. If the program has already started and you wish to change the program: ^ Open the door. [. . . ] ^ If it measures less, the water intake time must be increased (see the following page). 49 Solving problems Increasing the water intake time Procedure. . . ^ Press buttons b and d while simultaneously turning on the dishwasher with the "On" button (g) . Note: If any other indicator lights flash, repeat the procedure from the beginning. The following indicators may also be lit, if: ­ Rinse aid has not been added or needs to be refilled, ­ Heated drying is deactivated (see "Additional features") ­ The water intake time has been increased (see "Increasing the water intake time") ­ The End of program buzzer is deactivated (see "Additional features"). [. . . ]