User manual BELSON HH-1500AC

[. . . ] 4) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 5) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. 9) Before washing anything in the dishwasher check the information provided by this section. 6) Learn the right usage of detergent and rinse aid for best washing results. [. . . ] Interrupt the wash cycle by opening the appliance door with the utmost care, as usual, then insert the dish you had forgotten. When you shut the appliance door, the cycle will start up from where you interrupted it. The end of the wash cycle is indicated by a double beep and the flashing of the wash cycle indicator light "M". Open the dishwasher door, press the ON-OFF button as well, thus cutting off the electricity supply to the appliance. You can modify the wash cycle in progress, if it has If opening the only just started. Open door soon the appliance door after the end carefully to avoid any hot of the program, or water splashes, then during it, stand away keep button "P" pressed from the Dishwasher, for approximately 5 to avoid possible seconds, until you hear a injury from hot steam. Indicator light "M" will come off and at this point, all the settings will have been cancelled. Each time this button is pressed, one of the indicator lights "M" will come on in sequence, select the wash cycle you deem most suitable for the type of dishes to wash (take a look at page 7, where you will find the wash cycle table). Close the appliance door and after a few seconds, you will hear a short beep: the wash cycle has begun. The wash cycle stops and then restarts when the electricity comes back on or when you shut the door. A long beep will tell you that you have selected extra drying and the wash cycle will last longer in order to provide you with drier dishes. Put the dishwasher funnel on the hole and pour in approximately 70 oz. Never without salt Water hardness varies according to where you live. If the water in your home is hard you have the possibility to add salt in order to soften your water. The softer the water the better will be your washing and drying results. If the alarm persists, first turn off the water tap to avoid any flooding and then cut off the electricity supply and call for technical assistance. Troubleshooting Limescale deposits or a white film form on the dishes. S Is the wash cycle suitable for the dishes you have placed inside the appliance?Your dishwasher is equipped with a safety system which is able to detect any operating problems. These anomalies are reported by one or two wash cycle indicator lights "M" will flash rapidly. Take a note of which lights are flashing, turn the appliance off and call for technical assistance. You have checked everything, but the dishwasher still doesn't work and the problem persists? [. . . ] When the wash cycle has ended, always remenber to leave the appliance door ajar. Extended period of time, we recommend you do the following: • run a cycle with the dishwasher empty • turn off the water inlet tap. • leave the appliance door ajar This will help the seals last longer and prevent unpleasant odours from forming inside the appliance. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. [. . . ]