User manual BELSON CM2764

[. . . ] 4) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 5) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. 9) Before washing anything in the dishwasher check the information provided by this section. 6) Learn the right usage of detergent and rinse aid for best washing results. [. . . ] If the appliance door is shut, press the Start button "R" and you will hear a beep; the cycle will start up within a few seconds. Starting the dishwasher You have loaded your dishes and you now have to set the wash cycle. Interrupt the wash cycle by pressing the ON-OFF button, insert the dish you had forgotten and press the ON-OFF button again. The end of the wash cycle is indicated by two short beeps and the flashing of the drying phase indicator light. The end of the wash cycle is indicated by two short beeps and the flashing of the drying phase indicator light. •Turn the appliance off by pressing button "A", thus cutting off the electricity supply. • Wait a few minutes before unloading the dishes: they are very hot!Your dishwasher is fitted with indicator lights (G) which light up to indicate the cycle phase under way. At all times, your dishwasher tells you which cycle phase is under way. You can modify the wash cycle in progress, if it has only just started. Keep the RESET button "R" pressed for about 5 seconds: a prolonged beep will sound, followed by three short beeps. Special cycle to be used for more delicate items which are sensitive to high temperatures. Troubleshooting Your dishwasher may not work or not function properly. In many cases, these are problems which can be solved without having to call for a technician. Before calling the Customer Care Center, always check the points below. The dishwasher won't s Can the sprayer arms turn few short beeps for a few Water load solenoid valve minutes. If you were not home when these beeps are sounded, the appliance will be blocked automatically the 2nd and 3rd light from the right will flash rapidly. Turn the appliance off at the ON-OFF button, turn on the water tap and wait approximately 20 seconds before turning the appliance back on; the selected wash cycle will start up again. Clogged filter alarm If the appliance is blocked and the 2nd and the 4th light from the right flash rapidly, this means the filter is clogged by large particles of food residue. Turn the appliance off, clean the filter thoroughly and reposition it in its seat as illustrated on page 10. If the 3rd light from the right flashes rapidly, turn the dishwasher off and back on again after one minute. If the alarm persists, first turn off the water tap to avoid any flooding and then cut off the electricity supply and call for technical assistance. [. . . ] When the wash cycle has ended, always remenber to leave the appliance door ajar. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. To clean the exterior and rubber parts of your appliance, do not use solvents or abrasive cleaning products. If there are any stains on the surface of the appliance interior, use a cloth dampened with water and a little white vinegar, or a cleaning product specifically made for dishwashers. [. . . ]