User manual BEKO HSA24530

[. . . ] Make your old appliance useless : - disconnect the appliance from the supply; - remove the supply cord (cut it); - remove the eventual locks on the door to avoid the blocking of children inside, while playing, and the endangering of their lives. The refrigerating apliances contain insulating materials and refrigerants which require a proper recycling. This appliance is not intended for use by person with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] Before plugging in the appliance, please make sure that the parameters of the mains in your house (voltage, currect type, frequency) comply to the operation parameters of the appliance. € The information concerning the supply voltage and the absorbed power is given on the marking label placed in the back side of the freezer. The manufacturer has no responsibility for any damage to persons, animals or goods which may arise from the failure to observe the specified conditions. € The appliance is endowed with a supply cord and a plug (European type, marked 10/16A) with double earthing contact for safety. If the socket is not the same type with the plug, please ask a specialised electrician to change it. se tting up This appliance was designed to operate at an ambient temperature between +100C and +430C (SN/T class). If the ambient temperature is above +430C, inside the appliance the temperature can increase. Placing it in a warm room, the direct exposure to sunbeams or near a heat source (heaters, cookers, ovens), will increase the energy consumption and shorten the product life. € Please observe the following minimun distances: • 100 cm from the cookers working with coal or oil; • 150 cm from the electric and gas cookers. € Ensure the free circulation of the air around the appliance, by observing the distances shown in Item 2. € Place the appliance in a perfectly even, dry and well ventilated place. 3 GB Switc hing off The switching off must be possible by taking the plug out of the socket or by means of a mains two-poles switch placed before the socket. Instruction for use Freezer operation Temperature adjustment The temperature of the freezer is adjusted by means of the knob assembled on the thermostat (item. The achieved temperatures can vary according to the conditions of use of the appliance, such as: place of the appliance, ambient temperature, frequency of door opening, extent of filling with food of the freezer. The position of the thermostat knob will change according to these factors. The signalling system is placed on the front side of the freezer (Item 5). Green LED – shows that the appliance is supplied with electric energy. Red LED – damage – lights if the temperature in the freezer is too high. The LED will operate 15-45 minutes after the putting into operation of the freezer, then it must go off. If the LED goes on during the operation, this means that defects have occurred. Orange button– fast freeze – by pushing it the orange led goes on, showing that the appliance entered into the "fast freeze" mode . The exit of this mode is done by pushing the button again, and the orange led goes off. [. . . ] They are redced as soon as the appliance reaches the operation temperature. Instruction for use The bubbling and gurgling noises coming from the refrigerant circulating in the pipes of the appliance, are normal operating noises. Never try to repair yourself the appliance or its electric components. Any repair made by an unauthorised person is dangerous for the user and can result in the warranty cancellation. [. . . ]