User manual BEKO HNE51210S

[. . . ] The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels. The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and ignite. Accessible parts of the hood may became hot when used with cooking applicance. [. . . ] If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions. Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. Power cable replacement must be undertaken by the authorised service assistance centre or similar qualified person. mounting Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Remove the fats filter/s or the suction grill/s (depending On the model in possession ­see also the relative paragraph). This/these is/are to be mounted only if you want lo use the hood in the filtering version. Check (for transport reasons) that there is no other supplied material inside the hood (e. In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket is available and it is possible to connect a fumes discharge device to the outside (only suction version). Choose the discharge outlet to use: Only filtering version: use ONLY the upper B1 outlet (Fig. Check that this, once installation is completed, is not obstructed and that there is sufficient space so that the purified fumes and steam can return easily into the kitchen. 1) to take away the pre- Fractured part (B1 o B2) that closes the discharge outlet and remove it. Check that the lateral wall units between which to install the hood are sufficiently robust for installing the hood. Otherwise mount the hooking brackets on the wall (*) to use as additional supports: a. Insert each bracket from the rear inside the hood Fix the brackets with the screws and threaded bushes They will serve to adjust the position of the hood at the moment of installation. Note: the position of the brackets can be adjusted during installation, suitably loosening and retightening the screws that fix them to the hood. Extract the steam collector (freeing it from the blocking Put perforation diagram N3 on the REAR of aesthetic Panel J (the arrow on the diagram turned upward towards the UPPER EDGE of the aesthetic panel). Put the steam collector over the aesthetic panel and fix it with 8 screws L. Remount the door on the hood, first on upper guides M1, then on the lower M2. Close completely and re-open the door to check its correct sliding on the guides. 11 In some products an electrically or mechanically activated valve is envisaged instead of an aspiration motor. [. . . ] The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. If situated inside the support grill, it may be one of the following types: Paper filter must be replaced once a month or if colouring appears on upper side, in such cases the colouring is evident Sponge filter should be washed with hot soapy water once a month and replaced every 5 to 6 washes. Metallic filter must be cleaned once a month, with non abrasive detergents, by hand or in dishwasher on low temperature and short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. [. . . ]