User manual BEGLEC POLAR LASER V1.0

[. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Check the contents: Check that the carton contains the following items: Operating instructions Polar Laser Unit 2 keys (for key switch) Power Cable CAUTION: To reduce the risk of electric shock, do not remove the top cover. The minimum distance between light-output and the illuminated surface must be more than 1 meter To protect the environment, please try to recycle the packing material as much as possible. [. . . ] This product is a so-called show laser, emitting radiation with a wavelength spectrum between 400 and 700 nm and producing lighting effects for shows. Laser Light is different from any other light source with which you may be familiar. The light from this product can potentially cause eye injury if not set up and used properly. Laser light is thousands of times more concentrated than light from any other kind of light source. This concentration of light power can The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol means: indoor use only This symbol means: Read instructions This symbol means: Safety Class II appliance Cause instant eye injuries, primarily by burning the retina (the light sensitive portion at the back of the eye). Even if you cannot feel "heat" from a laser beam, it can still potentially injure or blind you or your audience. Even very small amounts of laser light are potentially hazardous even at long distances. Never look into the laser aperture or laser beams Never direct the laser beam to people or animals and never leave this device running unattended. The operation of a class 3B show laser is only allowed if the operation is controlled by a skilled and well-trained operator. Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. the parent document and cornerstone of laser safety standards ANSI Z136. 1 (2007) provides guidance for the safe use of lasers and laser systems by defining control measures for each of the four laser classes. Org Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation!To your own taste, perfect when the unit is used as background effect. SAFETY EYE: used to attach a safety cable when the unit is rigged (see paragraph "overhead rigging" 11. HANGING BRACKET: with 2 knobs on the sides to fasten the unit and a mounting hole to fix a mounting hook. Use the keys to make sure only a skilled operator is able to switch the laser on. MUSIC INPUT SENSITIVITY: This trimmer is used to adjust the music input sensitivity. [. . . ] Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. [. . . ]