User manual BEGLEC LM440 V1.1

[. . . ] 4 extra switch channels to switch light effects on/off via optional DMX switch pack (ex. SW416) 4 user modes: Individual manual dimming on all 4 channels (stage lighting) 4 Channel light modulator (high, mid, bass, anti-bass) 9 built-in 4channel chaser programs: audio controlled (built-in micro or external cinch audio input) static with user selectable speed on fader Individual dimmer faders on each channel, each with flash buttons. Master dimmer with overall flash button Background level dimmer Standby switch (blackout) DMX output for extra dimmer- and switch packs: DMX channels 1-4: dimmer channels DMX channels 5-8: on/off switch channels This symbol means: indoor use only. Check the contents: Check that the carton contains the following items: LM430 with AC-adapter or LM440G ~ LM440F User manual Some important instructions: Before you start using this unit, please check if there's no transportation damage. [. . . ] Switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. LM440G ~ LM440F must be earthed to in order comply with safety regulations. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Do not use volatile liquids such as benzene or thinner which will damage the unit. DIMMER CHANNELS: these are 4 faders used to set the individual dimming levels of the 4 channels. Below each fader there's a flash button to set the output of the corresponding channel to 100% (full) for as long as the button is pressed. The flash buttons all have backlight so you can easily monitor the output of each channel. SWITCH CHANNELS: these buttons are used to switch 4 individual light effects ON/OFF. To be able to use these buttons you must connect a separate switch pack to the DMX-output of the unit. MODE SELECT: used to select 1 of the 4 user modes: HOLD DIM: This mode can be used to control the dimming levels of projectors on a small stage. The 4 faders (2) can be used to set the dimming level of each channel individually. HOLD SOUND: the music is divided into 4 different frequency ranges (bass, middle, high, antibass). Each of the four output channels will respond to a different frequency range. PROGRAM SELECT: When you selected 1 of the 2 program modes (4) then you can use the program select button to choose the program you like. BACKGROUND LEVEL: with this fader you can set the background level (minimum output level) of the 4 dimmer channels. This can "soften" the chaser effects so they become less aggressive. Attention: don't set this fader to maximum, you will not be able anymore to see the chaser patterns or set proper dimming levels for the 4 individual channels. PROG SPEED CONTROL: When the "program speed" mode (4) is selected, you can change the speed of the selected chaser program (6) from slow to fast or very fast (13). [. . . ] When the problem is solved, simply push the button to reset the circuit breaker. CHANNEL OUTPUTS: (only on LM440G ~ LM440F) Each channel output has its own output socket to connect any resistive and/or inductive (PAR36) projector(s). Always replace a blown fuse with a fuse that has the same characteristics!It's very important to know that the maximum load for each channel is rated at 8A or 1750Watts. [. . . ]