User manual BEGLEC LED GROUND LIGHT V1.1

[. . . ] ⷠAll-weather proof IP67 design with stainless steel cover ring. ⷠCan be built-in any concrete (or other) floors, walls and ceilings. Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. [. . . ] ⷠSeparate the plastic niche mounting box (5) from the rest of the projector. ⷠFirst install the mounting box at the right spot in the floor. Close the projector after connecting the electrical wires (see next chapter) · Make sure the wire inlet on the waterproof metal housing is well fastened and sealed so that no water can come in. ⷠFix the metal enclosure to the niche mounting box using the 3 screws. ⷠMake sure the collar on the upper side of the metal housing is free from dirt or dust. ⷠMake sure the glass cover and its rubber sealing are clean and put them in place. ⷠInstall the stainless metal ring and fasten with the 3 special bolts. To protect the environment, please try to recycle the packing material as much as possible. This unit has protection class IP67 so it can be used outdoors when it is properly installed. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. The cables should always be in perfect condition: switch the LED Manager immediately off when the cables are squashed or damaged. This appliance must be used with the LED Manager: don't connect the unit to any dimmer pack or other power supply. In the event of serious operating problems, stop using the fixture and contact your dealer immediately. the housing and the lenses must be replaced if it is visibly damaged. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. VERY IMPORTANT: Check the user manual of the LED Manager for the maximum allowed power on its outputs!To know the total power consumption of all LED products in a chain you simply have to count up the power consumption of all units in the chain. Check the chapter "specifications" at the end of this manual to see the power consumption of the different LED STRIPS! ⷠSince the LED Manager uses special 4pin connecters on its power outputs, we suggest to buy an optional 1m extension cable (with special male/female 4pin connectors) and to cut the female connector. you will find 4 colored wires inside: · White wire: This is the common wire (anode) · Green wire: This the power for the green LEDs (max. [. . . ] ⷠWhen you install several projectors, you will surely need special waterproof junction boxes to make the junctions needed. ⷠAnother option is to open the waterproof metal enclosure (4) and to replace the original cable by your own cable. In this case you can make the connection immediately inside the projector so you don't need a special waterproof junction box. ⷠAfter checking that the maximum allowed power is not exceeded, you can connect the cable, coming from the projectors, to one of the outputs of the LED Manager. [. . . ]