User manual BEGLEC F-80Z

[. . . ] 5 kg CAUTIONS Pay attention to all warning labels and instructions printed on the exterior of your Antari Fog Machine Danger of electric shock Keep this device dry. Prior to use take care to determine that the unit is installed at the rated voltage. If moisture, water, or fog liquid gets inside the housing, immediately unplug the unit and contact a service technician or your Antari dealer before using it again. [. . . ] If fog liquid comes in contact with skin or eyes, rinse thoroughly with water. Unpacking & Inspection Open the shipping carton and check that all equipment necessary to operate the system has arrived intact. Before beginning initial setup of your Antari Fog Machine, make sure that there is no evident damage caused by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your Antari dealer for assistance. Fill with Antari Fog Liquid or other high-quality water-based fog fluid. Maintenance Operation 3 Plug power cord into a grounded electrical outlet. If necessary, turn power switch on rear of unit to "ON" position. to emit fog , press the button on the remote and hold for the desired length of time. The remote unit's lamp will cycle on and off as the machine re-heats to the proper operating temperature. For further information on operating your Antari Fog Machine, see the section titled, "Remote Control Operation". installation The F-80Z fog machine includes a mounting bracket designed for overhead installation. This bracket allows the unit to be hung from lighting equipment trussing or other suitable supports. The unit can also be operated at floor level or sitting on any regular surface as well. If the unit is to be mounted using the bracket, it is important that the fog does not shoot directly at any one's face. Therefore, do not point the nozzle in a direction that will aim directly at a person. Whatever installation method you choose, do not allow the unit to have more than a 15 degree angle of inclination. Remote Control Operation FCW-80: 3 meter wire remote controller with three-prong plug for Antari Fog Machine model F-80. Adjust the interval between each fog emission (within the range of 10 seconds to 5 minutes) by means of the INTERVAL control dial. [. . . ] If you are unable to determine the cause of the problem, do not simply continue pushing the remote button, as this may damage the unit. performance Notes All fog machines develop condensation around the output nozzle. Because this may result in some moisture accumulation on the surface below the output nozzle, consider this condensation when installing your unit. [. . . ]