User manual BAUKNECHT SKT60S INSTALLATION INSTRUCTION

[. . . ] These instructions are intended as a general guide only and do not supersede any national or local codes in any way. Compliance with all local, state or national codes pertaining to this type of installation should be determined prior to installation. NOTE: It is possible to make the trim kit fit vertical openings that are less than 74¹/" (189. 54 cm) must be cut from the base of both the left hand and right hand side extrusions. [. . . ] Using two people, one on each side, lift the trim assembly and position it into place above and on each side of the opening. Using a carpenter's level, level the top trim, and shim as necessary. Using two pan head Phillips screws, fasten the top trim extrusion by inserting a screw through the predrilled holes at each end. Using a carpenters level, make sure the sides are plumb, and shim as necessary. Using four pan head Phillips screws (two on each side), fasten both the left-hand and right-hand side trim extrusions to the opening or cabinetry. Use several pieces of tape to temporarily hold the assembly in place as shown. Using a cordless drill and ¹/" diameter drill bit, drill holes where marked. NOTE: Some cabinetry or wall materials may require predrilled holes using a /" diameter drill bit. Align the top extrusion against the opening, so that it is tight and flush with the front surface of the wall opening or cabinetry. Excessive Weight Hazard Use two or more people to move and install refrigerator. From below and behind the top trim extrusion, insert a pan head Phillips screw through the predrilled center hole of the top trim and into the wall opening or cabinetry. When Moving Your Freezer or Refrigerator: Your freezer and refrigerator are heavy. When moving the appliance for cleaning or service, be sure to cover the floor with cardboard or hardboard to avoid floor damage. Do not wiggle or "walk" the appliance when trying to move it, as floor damage could occur. Place the freezer and refrigerator in front of the opening (freezer on the left, refrigerator on the right). Slide the first appliance into the opening far enough to connect the power cord to the electrical outlet. Adjust the leveler legs so that each appliance is level and plumb and at the same height as the other appliance. NOTE: The freezer and refrigerator each have two front leveler legs that are adjustable. Failure to follow these instructions can result in death, fire, or electrical shock. Check the level of the appliance since it may have changed when you moved it into the opening. NOTE: The spacer ensures that the two appliances are positioned the correct distance apart from each other. Repeat Step 3 for the other appliance until both the freezer and refrigerator are level, plumb and at the same height. [. . . ] NOTE: Make sure the grille clips are fully engaged and that the base grille's side caps are situated outside the hinge bracket on each appliance. Remove the two /" hex head screws located on the opposite side from the bottom hinge on each cabinet. Insert one screw through the lower bracket and thread it into the cabinet. Align the bracket holes with the holes in the appliances and install the remaining three screws. [. . . ]