User manual B-52 MATRIX 2000

[. . . ] Servicing is required when the MATRIX 2000 has been damaged in any way!Please seek immediate service if the power-cord or plug is damaged, liquid has spilled into any of the cabinets, the unit has been exposed to moisture or rain, the unit does not operate normally, or has been dropped. To reduce the risk of fire or electric shock, do not expose the MATRIX 2000 to rain or moisture. The MATRIX 2000 is not intended for outdoor fixed installations or in high moisture areas. [. . . ] Turn the gain knobs all the way down before turning the system ON or OFF. Make sure the active subwoofer is connected to the two-way speakers before powering the system up. Make sure your mixer and all other signal sources are turned ON before connecting the MATRIX 2000. The MATRIX 2000 should always be switched ON last, after you switch ON all connected devices. 3 1 GETTING TO KNOW YOUR MATRIX 2000 AMPLIFIER 1. LEFT SPEAKER OUTPUT: Speakon-style connector output for left satellite speaker. Ensure these cooling fans are clear of external obstructions for efficient operation. VOLTAGE SWITCH: Enables the MATRIX 2000 to be switch from 115 volts to 230 volts. t m RIGHT SPEAKER OUTPUT: Speakon-style connector output for right satellite speaker. GROUND/LIFT SWITCH: Removes earth ground from circuit to eliminate excessive 60-cycle hum caused by ground loops. RIGHT SATELLITE GAIN CONTROL: Controls the levels of Gain to the right side satellite speaker. RIGHT FULL-RANGE OUTPUT: Sends full range signal out to other systems. RIGHT FULL-RANGE INPUT: Connect the right channel from your signal source to this connector (such as your mixer or CD player). LEFT SATELLITE GAIN CONTROL: Controls the levels of Gain to the left side satellite speaker. LEFT FULL-RANGE INPUT: Connect the left channel from your signal source to this connector (such as your mixer or CD player). REINFORCEMENT SCREW: This screw connects the amplifier panel to the subwoofer cabinet. Remove this screw in order to remove the amplifier from the subwoofer cabinet. This should only be done by an authorized B-52 Service Center. 2 IMPORTANT: VOLTAGE SWITCH & FUSE HOLDER U. S. A Customers: The MATRIX 2000 is already positioned to the correct voltage (115v) and has in place the correct fuse. DO NOT change the position of the voltage switch or fuse value while operating in the U. S. International Customers: The MATRIX 2000 is shipped internationally from our U. S. factory, with the voltage switch and fuse correctly set to your country's requirements. It is recommended that the subwoofers be placed near each other as this will result in low-frequency coupling and provide a stronger bass output. Step 1: Connect the RIGHT signal OUTPUT from your mixer or audio source to the RIGHT INPUT connector on the first MATRIX 2000 using a standard XLR cable. [. . . ] be liable for any incidental or consequential damages arising out of the use or inability to use of any B-52 product, even if E. T. I. or a B-52 dealer has been advised of the possibility of such damages, or any other claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. [. . . ]