User manual AT&T 922

[. . . ] Telephone Does Not Ring · Make sure the RINGER switch is set in the LO or HI position. · If there are several other telephones on the same line, try disconnecting some of the other telephones. Having too many telephones connected can also create problems such as low ringer volume, or impaired sound quality during calls. Other Problems Make sure you have followed all the instructions in this booklet. [. . . ] To answer a call, press the appropriate line button and lift the handset. Making a Call--Speakerphone NOTE: The red speakerphone light will go on when the speakerphone is being used. Wait for a dial tone, then dial the call manually or by using memory dialing. NOTE: Using an extension phone is not recommended while using the speakerphone. Volume Button The VOLUME button adjusts the speaker or the handset during your call. Line Status Lights Whenever a line is in use (at this telephone or any extension), the Line Status light for that line will be on. When a call is put on hold at this phone, the light for the line on hold blinks. NOTE: If the Line Status lights are not working properly, try installing new batteries. Redial The telephone always stores in memory the last number you called. The number (up to 24 digits) will remain in the Redial memory until you dial another number. To dial the same number again, select a line, lift the handset or press , listen for the dial tone , and press . Automatic Redial This phone can automatically and repeatedly redial the last number you called. When the call is answered, you must either lift the handset or press to talk. If the called line is busy, the phone will redial every 40 seconds up to 10 times (timing begins when the phone is on hook). Hold The Hold feature allows you to keep a call on the line while you step away from the phone, switch lines, or while someone takes the call on an extension phone. When a call is put on hold at this phone, the Line Status light for the line being used flashes; nothing either party says can be heard. To activate, press and release , and place the handset back in the cradle. When using the speakerphone, press and release . 3 To release Hold, press the appropriate line button, then lift the handset from the cradle -- OR -- Press -- OR -- Lift the handset of an extension phone of the line on hold -- OR -- If the handset is not in the cradle, press the appropriate line button, then lift the handset or press . Switching Between Lines During a Call During a call on one line, you can make or answer a call on the other line by pressing . You can use the and Line buttons to switch back and forth between calls as often as necessary. 3 Press to hang up Line 2 and return to your first call -- OR -- Press to hold Line 2, and press to return to your first call. Conference Calls You can use both lines at the same time to set up a three-way conference call. [. . . ] Dialing Long Numbers There are two ways to dial telephone numbers that are too long to fit into a memory location. Use Two Memory Locations You can store a number of more than 24 digits by dividing it and storing it in two memory locations. Follow the directions in "One-Touch Dialing" and "Two-Touch Dialing" to store the number in two memory locations. To dial, select a line, lift the handset or press , listen for a dial tone, then: · Press and release the memory button for the first location, and wait for the dialing to stop. [. . . ]