User manual APPLIED ENERGY GX9

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual APPLIED ENERGY GX9. We hope that this APPLIED ENERGY GX9 user guide will be useful to you.


APPLIED ENERGY GX9 : Download the complete user guide (1978 Ko)

Manual abstract: user guide APPLIED ENERGY GX9

Detailed instructions for use are in the User's Guide.

[. . . ] â· Do - Make sure the mains supply is switched off before attempting to make electrical connections or carry out any maintenance or cleaning. â· Don't - Install these fans in any window/panel which is less than 4mm thick. UK: The fan is guaranteed against defects for 3 years from the date of purchase. [. . . ] Go outside and cut a hole in the outer wall, repeating the process described above. For fixed wiring circuits the protective fuse for the appliance must not exceed 5A. Remove the inner grill and back draught shutter by first removing the screw from the underside of the grille then unclipping the bottom of the grille, the top of the grille can then be released by unclipping the top corner. NOTE: The top of the grille can only be released when the screw is removed and the bottom of the grille has been released (Fig. GX9 (switch operated): To switch on and off, use the switch on the wall or ceiling. gX9 (controller operated): Refer to the instructions for the controller. The shutters are operated by a silent thermo-actuator which has a time delay on opening (30-50 secs) and closing (3 mins). GXC9 (cord operated): To switch on, pull down the cord and then release it. Xpelair recommended that the instructions of this section are carried out by two people. If working above Ground Floor level, appropriate safety precautions must be observed. If installing the fan in a window, fix the three rubber edge protectors (packed separately) at equal distances around the lip of the Outer Clamp Plate. Hold the Outer Grille up to the outside of the wall or window so that the lip of the Outer Clamp Plate protrudes into the hole. Hold the Inner Clamp Plate to the inside of the wall or window and guide the Ladder Strips from the Outer Clamp Plate through the slots in the Inner Clamp Plate. Insert the slotted screws (packed separately) into the pockets around the ladder Strip slots. Trim the Ladder Strips back to the required length, if necessary remove any sharp edges. Remove the inner grill and back draught shutter by first removing the screw from the underside of the grille then unclipping the bottom of the grille, the top of the grille can then be released by unclipping the top corner. [. . . ] Remove the Fan Connector Plate carefully by unscrewing the two screws (Fig. If required, feed the cable through the grommet (packed separately) in order to fit to the cable entry of the Connector Plate. Set the Fan Selector Switch to Position 3 if using a controller providing variable speed and/or direction. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE APPLIED ENERGY GX9




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual APPLIED ENERGY GX9 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.