User manual AEG X69453MV02

[. . . ] Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc. If the extractor is used in conjunction with non electrical appliances (e. Gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Warning: Before installing the Hood, remove the protective films (white and transparent). Ty Product Components 1 1 Hood Body, complete with: Controls, Light, Blower, Filters 8 1 Directional Air Outlet grille 9 1 Reducer Flange ø 150-120 mm 10 1 Dumper 16 1 Filter cover Ref. 2 11a 1 247 247 1 12a 11 482 2 2 As a first step, proceed with the following drawings: • a vertical line up to the ceiling or up to the upper limit, at the centre of the area in which the hood is to be fitted; • a horizontal line at a minimum 1004 mm above the cooker top. € Mark a point (1) on the horizontal line, 247 mm to the right of the vertical reference line. € Repeat this operation on the other side, checking that the two marks are levelled. € Mark a reference point (2) as indicated at 210 mm from the vertical reference line and 482 mm above the cooker top. € Repeat this operation on the other side, checking that the two marks are levelled. € Insert the bracket plugs 11a into the holes (1) and tighten the screws. 1 on the wall, about 1-2 mm from the ceiling or from the upper limit, aligning the centre (notch) with the vertical reference line. 1 on the wall at X mm below the first bracket (X = height of the upper chimney section), aligning the centre (notch) with the vertical line. € Fix the brackets using the 12a screws (4, 2 x 44, 4) supplied with the hood. 1 EN - INSTALLATION 14 FITTING THE HOOD BODY • Open the top suction panel and fasten it to the hood body on the left using the pin, so that it does not close again. € Unlock the lower suction panel by removing the fixing pin on the left, and open it. € Adjust the two screws Vr, in the brackets 11a, so that they are at the start of their travel. [. . . ] All the Leds flash twice and during Keyboard Lock the Leds light up in sequence. This speed is timed to run for 5 minutes, after which the system will return to the speed that was previously set. Activates delayed automatic shutdown of the motor and the lighting system after 15 minuts. [. . . ]