User manual AEG WSLB 230 X

[. . . ] SAFETY INSTRUCTIONS Please pay attention to the safety instructions in the attached leaflet!Appliances used at many different locations including open air must be connected via a current surge preventing switch. [. . . ] Because of the danger of fire, no combustible materials should be located in the vicinity (spark flight zone). Due care should be taken that no sparks or sanding dust flying from the workpiece come into contact with you. The adjusting nut must be tightened before starting to work with the machine. When smoothing metals with the supporting disk and vulcanised fibre disks) strong contamination can build up inside the angle grinder. In this case, it is necessary to clean the inside thoroughly and free it from any metal deposit, due to safety reasons. After the current operated device has come into action, the machine must be subjected to maintenance. Under unfavourable power supply conditions, other equipment may be affected. If the system impedance of the power supply is lower than 0, 2 Ohm, disturbances are unlikely to occur. SPECIFIED CONDITIONS OF USE This angle grinder can be used for separating and grinding many different materials, e. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. MAINTENANCE The ventilation slots of the machine must be kept clear at all times. [. . . ] Always disconnect the plug from the socket before carrying out any work on the machine. Manager Product Development NÄTANSLUTNING Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]