User manual AEG WS 1000-125 X

[. . . ] Spindle lock Gear neck Working spindle Screw Guard Back flange Working tool Flange nut Steel­wire brush (Accessory*) On-/off switch Additional side handle Backing pad (Accessory*) Abrasive paper (Accessory*) Clamping flange (Accessory*) Guide shoe and Wheel guard (Accessory*) Appliances used at many different locations including open air must be connected via a current surge preventing switch. It is recommended to wear gloves, sturdy non slipping shoes and apron. [. . . ] Do not pierce the motor housing as this could damage the double insulation (use adhesives). Always disconnect the plug from the socket before carrying out any work on the machine. Only use diamond cutting discs that are sharp and in perfect condition. Replace diamond cutting discs at once if they have splits or are deformed. Due care should be taken that sparks flying from the work piece do not contact inflammable materials. When the machine is used under extreme humid conditions or is very contaminated with conductive dusts, we recommend the use of an ELCB safety switch (earth leakage circuit breaker) to increase your personal safety. Typically the A-weighted sound pressure level of the tool is 85 dB (A). When fitting the plug, make sure that the brown (live) wire of this appliance is connected to the plug terminal marked L or coloured red, and the blue (neutral) wire of this appliance is connected to the plug terminal marked N or coloured black. Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol or coloured green or green/yellow. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Atlas Copco Elektrowerkzeuge GmbH, Postfach 320, D­71361 Winnenden. Intermittant Use Switching on: Push forward on­off control (LEERER MERKER) without pressure Switching off: Release on­off control Continuous Use Switching on: Push forward on­off control wSL 115 XS , WSL 125 X , WS 100 S , WS 1000-125 X , WS 125 S Modifications: Text , diagrams and data are correct at the time of printing. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. Se till att maskinen är frånkopplad innan den anslutes till nätet. [. . . ] Se till att maskinen är frånkopplad innan den anslutes till nätet. Skyddskåpans läge kan anpassas till arbetsförloppets gång motsvarande de föreliggande fordringarna; därvid bör man se till, att slipskivan kan rotera fritt. [. . . ]