User manual AEG TS 250 K

[. . . ] Support large panels to minimise the risk of blade pinching and kickback. Supports must be placed under the panel on both sides, near the line of cut and near the edge of the panel. Before use check machine, cable, and plug for any damages or material fatigue. [. . . ] It is recommended to wear gloves, sturdy non slipping shoes and apron. Always disconnect the plug from the socket before carrying out any work on the machine. Sawdust and splinters must not be removed while the machine is running. From habit of checking to see that keys and adjusting wrenches are removed from tool before turning it , , ON". Incorrect spacing, positioning and alignment can make the riving knife ineffective in preventing kickback. The teeth thickness, or the set of the teeth must be thicker than the body of the blade and the riving knife. Only move the workpiece in counter rotation to sawblade (only work oppositely oriented)!For security, use devices such as safety- and pressure device, guide slide, rip fence, etc. Move the rip fence out of the way when cross-cutting Never use the fence as a cut-off gauge when cross-cutting. When blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from the work or pull the saw backward while the blade is in motion or kickback may occur. Do not use any flanges other than those supplied or indicated in the instruction manual to secure the saw blade. Refrain from removing any cut-offs or other parts of the workpiece from the cutting area whilst the machine is running and the saw head is not in the rest position. Stock having a round or irregular cross section (such as firewood) must not be cut, as it can not be securely held during cutting. When sawing thin stock layed on edge, a suitable auxilary fence must be used for firm support. Transport and store the tools in a suitable receptacle; Only use tools that meet standard EN 847-1. To minimise noise, the tool must be sharpened and all noise reducing elements (covers etc. Cutting rebates or grooves is only permitted with a suitable protective device fi tted, e. [. . . ] We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]