User manual AEG STEP 1200 XE

[. . . ] In case the base plate can't be tensioned anymore after frequent adjusting, the base plate setting mechanism can be re-adjusted. Typically, the A-weighted noise levels of the tool are: Sound power level (K = 3 dB(A)). [. . . ] Read all safety warnings and all instructions, including those given in the accompanying brochure. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Contact with a , , live" wire will also make exposed metal parts of the power tool , , live" and shock the operator. Appliances used at many different locations including open air should be connected via a residual current device of 30 mA or less. It is recommended to wear gloves, sturdy non slipping shoes and apron. Sawdust and splinters must not be removed while the machine is running. Always disconnect the plug from the socket before carrying out any work on the machine. Plunge cuts without pre­drilling a hole are possible with soft materials (wood, light building materials for walls). Harder materials (metals) must first be drilled with a hole corresponding to the size of the saw blade. SPECIFIED CONDITIONS OF USE This jig saw can cut wood, plastic and metal; it can cut straight lines, bevels, curves, and internal cut­outs. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. Under the effect of extreme electromagnetic interferences from the outside, temporary variations in the speed of rotation could arise in particular cases. [. . . ] In observance of European Directive 2002/96/ EC on waste electrical and electronic equipment and its implementation in accordance with national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. NÄTANSLUTNING Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]