User manual AEG SE 12-180

[. . . ] Switch can be locked Schalter ist arretierbar Le commutateur peut être verrouillé L`interruttore si può bloccare El interruptor se puede bloquear. Switch cannot be locked Schalter ist nicht arretierbar Le commutateur ne peut pas être verrouillé L`interruttore non si può bloccare El interruptor no se puede bloquear. Typical A-weighted sound levels: Sound pressure level (dB (A)) (K = 3 dB(A)) . [. . . ] Always disconnect the plug from the socket before carrying out any work on the machine. Only use tools whose permitted speed is at least as high as the highest no-load speed of the machine. Immediately switch off the machine in case of considerable vibrations or if other malfunctions occur. Always use and store the grinding disks according to the manufacturer's instructions. Because of the danger of fire, no combustible materials should be located in the vicinity (spark flight zone). Due care should be taken that no sparks or sanding dust flying from the workpiece come into contact with you. The adjusting nut must be tightened before starting to work with the machine. Smooth-grinding metals with the arbour and vulcanized fibre grinding wheel), significant contamination can build up on the inside of the angle grinder. For safety reasons, in such conditions the inside should be cleaned thoroughly of metal deposits and a motor circuit-breaker must be connected in series. if the motor circuit-breaker trips the machine must be sent for repair. For tools intended to be fitted with threaded hole wheel, ensure that the thread in the wheel is long enough to accept the spindle length. SPECIFIED CONDITIONS OF USE This angle grinder can be used for separating and grinding many different materials, e. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. [. . . ] Do not dispose of electric tools together with household waste material!In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]