User manual AEG SB 20-2 E

[. . . ] It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. SYMBOLS Please read the instructions carefully before starting the machine. [. . . ] An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. It is recommended to wear gloves, sturdy non slipping shoes and apron. Sawdust and splinters must not be removed while the machine is running. Always disconnect the plug from the socket before carrying out any work on the machine. When working with large drill diameters, the auxiliary handle must be fastened in a right angle with the main handle (see illustrations, section Twisting the handle). When working in walls ceiling, or floor, take care to avoid electric cables and gas or waterpipes. SPECIFIED CONDITIONS OF USE The electronic drill/screwdriver can be universally used for drilling, percussion drilling, screwdriving and cutting screw threads. MAINTENANCE The ventilation slots of the machine must be kept clear at all times. If the machine is mainly used for percussion drilling, regularly remove collected dust from the chuck. To remove the dust hold the machine with the chuck facing down vertically, and completely open and close the chuck. Should components need to be replaced which have not been described, please contact one of our Milwaukee service agents (see our list of guarantee/service addresses). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Milwaukee Electric Tool, Max-Eyth-Straße 10, D-71364 Winnenden, Germany. [. . . ] Contact with a , , live" wire will also make exposed metal parts of the power tool , , live" and shock the operator. Appliances used at many different locations including open air should be connected via a residual current device of 30 mA or less. NÄTANSLUTNING Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]