User manual AEG PNEUMATIC 5000 E

[. . . ] Advice for your safety Please pay attention to the safety instructions in the attached leaflet!Appliances used at many different locations including open air must be connected via a current surge preventing switch. It is recommended to wear gloves, sturdy non slipping shoes and apron. [. . . ] Similar to hitting a common chisel with a hammer, a plunger hits the axially moving chisel. The electric motor moves the plunger back and forth crank drive ­> piston ­> freely moving piston. There is a pneumatic cushion between piston and freely moving piston (pneumatic hammer mechanism). Exerting greater power does not increase the machine's effectiveness. Anti Vibration System AVS The hammer mechanism and motor are independant of the handgrips, cushioning elements absorb vibrations on both handgrips when hammering and chiselling. Hammer drilling chuck for bits and accessories with SDS-max reception ­ tools are locked automatically after insertion. Built-in safety clutch helps prevent the machine from rotating if the drill bit jams. Switch trigger for switching the machine on and off, and for smooth starting and varying speed. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. Switching on: Press switch trigger Switching off: Release switch trigger The speed can be infinitely varied by slowly releasing/pressing the switch trigger. Always disconnect the plug from the socket before carrying out any work on the machine. The following tools can be inserted in the drill-hammer chuck using the SDS-max shank: ­ Hammer-drill for concrete and brickwork ­ Pointed chisel, flat chisel, hollow chisel, tile chisel Only use accessories with SDS-max shank!Push bit into chuck turning it slightly, the It must be possible to move it back and forth. Switching between hammer drilling, chiselling Depending on the inserted tool the machine can be operated with additional rotation (SDS­max­drills) or without additional rotation (SDS­max­chisels). In "free turning position" the chisel can be turned by hand to the required angle. Afterwards lock the spindle with the selector lever while turning the chisel slightly. [. . . ] The location of your nearest service station is shown in our "Service adresses" leaflet attached to each product. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320, D­71361 Winnenden. [. . . ]