User manual AEG PNEUMATIC 3000 SUPER X2

[. . . ] SAFETY INSTRUCTIONS Please pay attention to the safety instructions in the attached leaflet! [. . . ] SPECIFIED CONDITIONS OF USE The rotary pneumatic hammer can be used for hammer drilling, chiselling in stone and drilling in wood, metal as well as plastic. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. EN 50144, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3, in accordance with the regulations 98/37/EC, 89/336/EEC MAINS CONNECTION Connect only to single-phase a. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. eLECTRONICS Protection of motor in case of overload: Motor protection device controlled by motor load. The machine will slowly continue to run in order to cool the motor down. After sufficient cooling machine can be restarted by switching off and on again (only applicable for PN 3000 SUPER X2, PN 3000 SUPER XN2, FIXTEC PLUS). Under the effect of extreme electromagnetic interferences from the outside, temporary variations in the speed of rotation could arise in particular cases. [. . . ] Bestämmelser och riktlinjerna 98/37/EG, 89/336/EWG NÄTANSLUTNING Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]