User manual AEG PBA 7224 MB

[. . . ] 500 g SAFETY INSTRUCTIONS Please pay attention to the safety instructions in the attached leaflet!Do not dispose of used battery packs in the household refuse or by burning them. [. . . ] Never break open battery packs and chargers and store only in dry rooms. Please pay attention to the following symbol on the label of the charger: This tool is only suitable for indoor use. Before use check machine, cable, and plug for any damages or material fatigue. SPECIFIED CONDITIONS OF USE The quick charger can charge AEG batteries from 7. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. BATTERIES New battery packs reach full loading capacity after 4 - 5 chargings and dischargings. Battery packs which have not been used for some time should be recharged before use. General note concerning NiMH batteries: The capacity of the battery is reduced when the temperature falls below -10°C. Long-term storage at temperatures higher than +40°C may have negative effects on the capacity of the battery. CHARACTERISTICS After inserting the battery into the reception of the charger the battery will automatically be charged (yellow control lamp is illuminated continuously) When a hot or cold battery pack is inserted into the charger (flashing yellow lamp), charging will begin automatically once the battery reaches the correct charging temperature (5°C. Charging time varies depending on the battery temperature, charge needed and the type of battery pack being charged. As soon as charging is completed, the charger switches over to "trickle" charge to maintain the full capacity (green control lamp is illuminated continuously) It is not necessary to remove the battery after charging. [. . . ] As well as the machine type printed on the label and order the drawing at your local service agents or directly at: AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden, Germany. NÄTANSLUTNING Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]