User manual AEG NT 1500 A

[. . . ] 6, 8 kg J Please pay attention to the safety instructions in the attached leaflet!J Appliances used at many different locations including open air must be connected via a current surge preventing switch. J Do not drill the housing, as the protective insulation would be rendered ineffective. [. . . ] When fitting the plug, make sure that the brown (live) wire of this appliance is connected to the plug terminal marked L or coloured red and the blue (neutral) wire of this appliance is connected to the plug terminal marked N or coloured black. Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol or coloured green or green/yellow 1 NT 1200, NT 1500 A Advice for your safety Switch for automatic operation (only applicable for NT 1500 A) Pilot light for automatic operation (only applicable for NT 1500 A) Socket for power tool (only applicable for NT 1500 A) In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. Always disconnect the plug from the socket before carrying out any work on the machine. (The container can only be stood on its head for the castors to be mounted. Firmly by hand into the provided borings of the container base, as far as they will go. With the markings lined up to one another, and listen for the hose to snap into place. To remove the vacuum hose, turn the connector slightly to the right or the left and pull it out. Fit together the all­purpose nozzle, the two suction tubes, and the suction hose. Fit the upholstery nozzle directly onto the vacuum hose or onto one of the vacuum tubes. Connect the mains cable of the power tool with the socket of the vacuum cleaner. In automatic operation, the vacuum cleaner starts automatically when the power tool is switched on. Paper dust-sack Inserting the paper dust-sack Use the paper dust-sack as well when sweeping up fine dust such as sawdust, soot, ashes, etc. Take hold of the paper dust-sack by the Cardboard edges and press them firmly against the vacuum hose connector. Fit the paper dust-sack against the wall of Switch is located above the aspiration hole and snap shut the grips. To switch on automatic control: set switch to "A" and turn the On/Off switch to "I" ­ the pilot light comes on. If a power tool is connected to the plug, the vacuum cleaner is switched on automatically together with the power tool To switch off automatic control: set switch to "N" ­ the pilot light goes out. Take care when vacuuming dry matter that all parts are completely dry, particularly the filter cartridge. Additionally use the paper filter bag when vacuuming fine dusts like grinding dust, soot, ashes, or similar. [. . . ] possible causes: - Filter cartridge not fitted properly - Filter cartridge damaged. If the malfunction is not caused by any of the above possibilities, please contact your local AEG after­sales services. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). [. . . ]