User manual AEG MFE 1500

[. . . ] SAFETY INSTRUCTIONS Please pay attention to the safety instructions in the attached leaflet!Appliances used at many different locations including open air must be connected via a current surge preventing switch. [. . . ] Only use and store diamond cutting discs according to the manufacturer`s instructions. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. Under unfavourable power supply conditions, other equipment may be affected. If the system impedance of the power supply is lower than 0, 2 Ohm, disturbances are unlikely to occur. SPECIFIED CONDITIONS OF USE The wall-chaser machine cuts slots for cables and pipes (masonry grooves) in any kind of brickwork with two diamond cutting discs running parallel to each other. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. If the overload protection switches it off frequently, reduce the cutting pressure or depth of cut. the infinitely variable cutting width setting has the advantage that , if the groove width is set correctly , pipes etc. Can be fitted precisely into the groove and it is not necessary to secure them with nails etc. Sharpen blunt diamond cutting blades (can be recognised by sparks flying while cutting) by making several cuts into calcareous sandstone or a special sharpening stone. [. . . ] NÄTANSLUTNING Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. NAUDOJIMAS PAGAL PASKIRT Mro prapjov freza dviem lygiagreciais deimantiniais abrazyviniais diskais bet kokiame mre pjauna laid ir kabeli kanalus (sienos griovelius). [. . . ]