User manual AEG MFE 1305

[. . . ] S Please pay attention to the safety instructions in the attached leaflet!S Do not pierce the motor housing as this could damage the double insulation (use adhesives). S Always pull the plug from the mains before making any settings or carrying out maintenance. S Before use check machine, cable, and plug for any damages or material fatigue. [. . . ] Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol, or coloured green or green/yellow. The speed of rotation is adjusted electronically when the load increases. In case of a longer overload period the speed is decreased electronically. the duration of cooling-down period depends on the grade of overload. Under the effect of extreme electromagnetic interferences from the outside, temporary variations in the speed of rotation could arise in particular cases. The electronic smooth start will prolong the life of both the motor and the gears. Electronic speed adjustment ensures constant speed even when the load on the motor varies. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. Insert the suction hose connector into the adapter until it sits firmly. Connect the other end of the suction hose to a vacuum cleaner which is suited for dust extraction. They are suited for sucking off large quantities of stone dust and allow the machine to be connected directly to the socket of the vacuum cleaner. When the machine is switched on the vacuum cleaner starts automatically. Always disconnect the plug from the socket before carrying out any work on the machine. Pull off diamond cutting discs and spacing washers from the bearing flange. Fit the new diamond cutting discs together with the spacing washers and tighten the flange nut with the two hole spanner. The number of spacing washers between the diamond cutting discs determines the cutting width. Arrow on diamond cutting discs must agree with arrow on protective hood cover-direction of rotation. Fit protective hood cover and support guide and set the cutting depth with the starshaped knob. The number of spacing washers between the diamond cutting discs determines the cutting width. Put the according number of distance washers between the diamond cutting discs and flange nut. [. . . ] For that purpose a spacing washer must be mounted between bearing flange and diamond cutting disk (the remaining spacing washers must be mounted between diamond cutting disk and flange nut). Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320, D-71361 Winnenden. S Se till att maskinen är frånkopplad innan den anslutes till nätet. [. . . ]