User manual AEG KH 5 E

[. . . ] SPECIFIED CONDITIONS OF USE KH 5 E: The pneumatic hammer can be universally used for hammer drilling and chiselling in stone and concrete. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents: EN 60745, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3, in accordance with the regulations 98/37/EC, 2004/108/EC, 2000/14/EC (MH 5 E) SYMBOLS Please read the instructions carefully before starting the machine. [. . . ] Note: To be accurate, an estimation of the level of ex-posure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. SAFETY INSTRUCTIONS Please pay attention to the safety instructions in the attached leaflet!Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a , , live" wire may make exposed metal parts of the power tool , , live" and shock the operator. Appliances used at many different locations including open air must be connected via a residual current device (FI, RCD, PRCD). It is recommended to wear gloves, sturdy non slipping shoes and apron. Sawdust and splinters must not be removed while the machine is running. Always disconnect the plug from the socket before carrying out any work on the machine. When working in walls ceiling, or floor, take care to avoid electric cables and gas or waterpipes. Always disconnect the plug from the socket before carrying out any work on the machine. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. [. . . ] In observance of European Directive 2002/96/ EC on waste electrical and electronic equipment and its implementation in accordance with national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]