User manual AEG HK 46 N

[. . . ] Advice for your safety J Please pay attention to the safety instructions in the attached leaflet!J Always disconnect the plug from the socket before carrying out any work on the machine. It is recommended to wear gloves, sturdy non slipping shoes and apron. J Sawdust and splinters must not be removed while the machine is running. [. . . ] Switch lock ­ prevents the machine from being switched on accidentally. When the machine is applied to the working material the cover swings back automatically. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. This electronic circular saw can cut lengthways and mitre accurately in wood, plastic, and aluminium. Connect only to a single-phase AC current supply and only to the mains voltage specified on the rating plate. When fitting the plug, make sure that the brown (live) wire of this appliance is connected to the plug terminal marked L or coloured red, and the blue (neutral) wire of this appliance is connected to the plug terminal marked N or coloured black. Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol or coloured green or green/yellow. Always disconnect the plug from the socket before carrying out any work on the machine. Hold the work spindle still by means of a wooden wedge between the saw blade teeth and the guide plate. Unscrew the tension screw with the Fit the new saw blade by following the For the cleanest possible cut, set the cutting depth whenever possible 5 mm deeper than the thickness of the material. The distance between riving knife and saw blade must not be more than 5 mm. For plunge cuts) the distance must be kept by all means when re-inserting the riving knife. Refit the riving knife by all means after plunge cutting before starting to work again. Adjusting the riving knife Set the distance between the riving knife and the tips of the saw blade teeth to a maximum of 5 mm, and adjust to a maximum distance of 5 mm between the tip of the riving knife and the lowest point of the saw blade. A dust bag or suction hose with adaptor can be attached to the machine for sawdust removal with an wet- and- dry vacuum cleaner. We recommend the AEG NTE 1100 electronic wet­and­dry vacuum cleaner, which has a socket to which this machine can be connected directly. As soon as the saw is switched on, the wet­and­dry vacuum cleaner switches itself on automatically. Slacken the wing-nut and set the rip fence to the required cutting width by means of the cutting line scale. [. . . ] Fixing a thin board of wood to the workpiece and sawing through both will also avoid tearing out effectively. In order to guarantee constant readiness for operation, the machine should be checked for worn carbon brushes at one of the AEG after­sales service agencies. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320, D­71361 Winnenden. [. . . ]