User manual AEG H 750

[. . . ] 3, 8 kg J Please pay attention to the safety instructions in the attached leaflet!J Appliances used at many different locations including open air must be connected via a current surge preventing switch. It is recommended to wear gloves, sturdy non slipping shoes and apron. [. . . ] When fitting the plug, make sure that the brown (live) wire of this appliance is connected to the plug terminal marked L or coloured red, and the blue (neutral) wire of this appliance is connected to the plug terminal marked N or coloured black. Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol or coloured green or green/yellow. Advice for your safety Brief description Switching on the machine is only possible when pressing the switch­lock (for your safety). On-/off switch The planing depth can be infinitely varied by means of the adjusting wheel. (only applicable for HBE 800) Protective swing cover swings back automatically or can be operated by hand using the lever. Hard metal cutters, old­fashioned plane blades (for rough­planing with adze­marks), and plane blades with grooves for splitting shavings (for easier shavings discharge at greater planing depths), can be fitted into the blade drive shaft. The old­fashioned plane blades and the grooved plane blades are available as accessories. The base of the plane is angled so that it can be brought on to the material more accurately, and is fitted with a V­shaped groove for chamfering edges. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. For safety reasons this power tool is fitted with a switch lock and the On-/Off switch cannot be locked in the "On" position. Always disconnect the plug from the socket before carrying out any work on the machine. As soon as one of the edges of the plane blades becomes blunt please turn plane blade or if worn out replace planer blades (only in pairs!Press the blade drive cover (E) down and Pull the tension unit (D) out to the side complete with the planer blade. Pull the planer blade out of the tension Clean the tension unit (D) and the blade Push the new planer blade all the way in at The side of the tension unit, making sure that the cam on the tension unit fits into the groove in the planing blade. Push the tension unit with the new planer Blade into the drive shaft so that the edge of the planer blade is level with the edge of the housing (G). Turn the drive shaft through 180o and change the second set of planer blades as described. Do not move the adjusting screws (H) ­ the tension unit is adjusted in the factory. When using the grooved planer blades (K), always use two blades with a different number of grooves. [. . . ] In order to guarantee constant readiness for operation, the machine should be checked for worn carbon brushes at one of the AEG after­sales service agencies. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320, D­71361 Winnenden. [. . . ]