User manual AEG DSB2E 1500

[. . . ] You have high standards and expect to purchase quality goods ­ quality offered by AEG. Please read the instructions for use before first operation so you can handle your power tool effectively and safely. We are sure that buying an Electric Power Tool from AEG was the right choice! [. . . ] Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol or coloured green or green/yellow. Centre bit Dry diamond core cutter Adaptor reducer Built­in safety clutch in both gear stages prevents rotating of the machine in case the core cutter is jammed. Motor protection device controlled by motor load ­ heat controlled shut-off if overloading is great. Always disconnect the plug from the socket before carrying out any work on the machine. And loosen the drill chuck to the left by tapping it lightly with a rubber hammer. Switch trigger for switching the machine on and off, and for smooth starting and varying speed. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. Insert chuck key successively into all 3 Removal of the working tools Mounting the core cutter (Standard system) Rotate eccentric cam anticlockwise using key. Always disconnect the plug from the socket before carrying out any work on the machine. Switching over drilling percussion drilling (only applicable for DSB2E 1500) Changeover drilling/hammer drilling with switch Drilling: Turn arrow towards handle Turn arrow towards Only change over when machine is slowing down. Intermittent use Switching on: Press On-/off switch Switching off: Release On-/off switch Continuous use Switching on: Press the On-/off switch and then the locking button, after that release on-off switch. Protection of motor in case of overload Motor protection device controlled by motor load ­ heat controlled shut-off if overloading is great. The machine will slowly continue to run in order to cool the motor down. After sufficient cooling machine can be restarted by switching off and on again. [. . . ] Should components need to be exchanged which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). Endast till enfas-växelström och endast till den nätspänning som finns angiven på effektskylten. We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. [. . . ]