User manual AEG BWS 12 C

[. . . ] 374 g Noise/Vibration Information Measured values determined according to EN 60 745 Typically the A-weighted sound pressure level of the tool is: Sound pressure level (K = 3 dB(A)) . Total vibration values (vector sum in the three axes) determined according to EN 60745. Read all safety warnings and all instructions, including those given in the accompanying brochure. [. . . ] use only System PCLS chargers for charging System PCLS battery packs. Battery acid may leak from damaged batteries under extreme load or extreme temperatures. In case of contact with battery acid wash it off immediately with soap and water. In case of eye contact rinse thoroughly for at least 10 minutes and immediately seek medical attention. SPECIFIED CONDITIONS OF USE The Maschine can be combined with different tools and is designed for following use: Right Angle Head: for drilling and screwing in wood, metal and plastics. Sander Head: sanding wood, metal and plastics Segment saw blade head: for cutting flush to a surface in wood and plastics. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. BATTERIES New battery packs reach full loading capacity after 4 - 5 chargings and dischargings. Battery packs which have not been used for some time should be recharged before use. BATTERY PACK PROTECTION The battery pack has overload protection that protects it from being overloaded and helps to ensure long life. under extreme stress the battery electronics switch off the machine automatically. If the machine does not start up again, the battery pack may have discharged completely. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden, Germany. [. . . ] An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. [. . . ]