User manual AEG BS12C

[. . . ] Children should be supervised in order to ensure that they do not play with the tool. SPECIFIED CONDITIONS OF USE The battery drill/screwdriver is designed for drilling and screwdriving for independent use away from mains supply. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. [. . . ] As soon as charging is completed, the charger switches over to "trickle" charge to maintain the full capacity (green control lamp is illuminated continuously) It is not necessary to remove the battery after charging. The battery can be stored permanently in the charger without the danger of being overcharged. If both LEDs flash at the same time, either the battery has not been completely mounted or there is a fault in the battery or the charger. For safety reasons you must stop using the charger and battery immediately and have them inspected by an AEG Customer Service Centre. *1Measured according to AEG norm N 877318 *2 The values stated are reference values. WARNING The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. the declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Read all safety warnings and all instructions, including those given in the accompanying brochure. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. SAFETY INSTRUCTIONS Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Contact with a , , live" wire will also make exposed metal parts of the power tool , , live" and shock the operator. Sawdust and splinters must not be removed while the machine is running. When working in walls ceiling, or floor, take care to avoid electric cables and gas or waterpipes. [. . . ] Of (of storage battery) battery cells 12 V L1215 <=1, 5 Ah 3 Do not try to charge non-chargeable batteries with this charger. No metal parts must be allowed to enter the battery section of the charger (short circuit risk). Never break open battery packs and chargers and store only in dry rooms. Before use check machine, cable, and plug for any damages or material fatigue. [. . . ]